Materials:
Name | Quantity | Picture | Link | Notes |
Ecoflex 00-30 Silicone | 1 | Via Amazon | ||
Zip-Tie | 1 | Via Amazon | ||
1/8" Tubing | at least 2" | Via Amazon | ||
1/4" Tubing | at least 1" | Via Amazon | ||
Filament | at least 350g | Via Adafruit | Will depend on your printer | |
Luer Fitting | 1 | Via Cole Parmer |
Tools:
Name | Notes |
3D Printer | Must have a z-axis of at least 100mm |
Clamps | |
Cup | |
Spoon | |
Scoop | |
Screwdriver | |
Flush Snips |
Materials:
Name | Quantity | Picture | Link | Notes |
Ecoflex 00-30 Silicone | 1 | Via Amazon | ||
Zip-Tie | 2 | Via Amazon | ||
Filament | at least 150g | Via Adafruit | Will depend on your printer | |
1/8" Tubing | 2 lengths of at least 3" | Via Amazon | ||
Luer Fitting | 1 | Via Cole Parmer |
Tools:
Name | Notes |
3D Printer | Must have a z-axis of at least 100mm |
Clamp | |
Cup | |
Spoon | |
Scoop | |
Flush Snips | |
Syringe | An air compressor or squeeze bulb could be used too |
Materials:
Name | Quantity | Picture | Link | Notes |
Arduino Uno | 1 | Via Adafruit | An Arduino Leonardo could also be used here | |
Half-Sized Breadboard | 1 | Via Adafruit | ||
10KΩ Resistor | 3 | Via Adafruit | ||
2.7KΩ Resistor | 2 | Via Amazon | ||
1KΩ Resistor | 1 | Via Amazon | ||
0.1uF Capacitor | 2 | Via Amazon | ||
10uF 50v Electrolytic Capacitor | 2 | Via Amazon | ||
LM358 Dual Op-Amp | 1 | Via SparkFun | Any of the LM358-series chips will work | |
MPS20N0040D-D Pressure Sensor | 1 | Via Amazon | ||
Male-to-Male Jumper Wires | 10 | Via Adafruit |
Name | Quantity | Picture | Link | Notes |
Arduino Micro | 1 | Via Adafruit | ||
Half-sized Perma-Proto Board | 1 | Via Adafruit | ||
10KΩ Resistor | 3 | Via Adafruit | ||
2.7KΩ Resistor | 2 | Via Amazon | ||
1KΩ Resistor | 1 | Via Amazon | ||
0.1uF Capacitor | 2 | Via Amazon | ||
10uF 50v Electrolytic Capacitor | 2 | Via Amazon | ||
LM358 Dual Op-Amp | 1 | Via SparkFun | Any of the LM358-series chips will work | |
MPS20N0040D-D Pressure Sensor | 1 | Via Amazon | ||
22AWG Solid-Core Wire | at least 10" | Via Adafruit | ||
DIP-8 IC Socket | 1 | Via Amazon | ||
Female Headers | 1 | Via Adafruit | ||
Solder | 1 | Via Adafruit |
Tools:
Name | Notes |
Flush Snips | |
Wire Strippers | |
Soldering Iron | |
PCB Vice | Optional, but will come in handy when soldering |