#  Control Board Design 

 



 ##  

  expand\_more  

 
  

 

The design of the control board was based on the [fluidic control board](/book/control-board) in the soft robotics toolkit.

A few key differences to note are:

- Pressure sensors were eliminated to reduce cost.
- An 8-valve manifold was used to leave room for future expansion.
- Instead of an on-board compressor, an off-board workshop air compressor supplies the necessary pressurized air.
- Power is provided by one 12V DC and one 24V DC supply.
- A sensor shield (daughter board) was used with the microcontroller to make electrical connections easier.
- Five potentiometers (one for each finger) provide manual control over each actuator.
- One potentiometer allows you to vary the Pulse Width Modulation (PWM) frequency used to control the flow of air to the actuators.
- A toggle switch allows you to either select manual control with the five potentiometers, or programmed control.
- A 12-position rotary switch lets you select between twelve different hand positions and gestures.
- Choice of black for the color is much cooler.

   ![Completed control board](/sites/g/files/omnuum4601/files/styles/hwp_1_1__720x720_scale/public/srtdesigncomp/files/ps_fluidiccontrolboard_121850_square_small.jpg?itok=RY9aq7Kc)