Handle

Handle Building instructions

  1. Cut 3/4"PVC pipe to 5 in. long, sand flat both ends

  2. Cut 6in of tubing

  3. Cut the PVC first according to this drawing.  
    screen_shot_2016-06-28_at_2.47.38_pm.png
      
  4. Then finish cutting bulb pattern out of the 5 in. PVC with the bulb and PVC elbow temprarally  attatched      
    img_2186.jpg

  5. Mark where your thumb will hit the 90 degree PVC elbow when the bulb is in place.

    20160628_150030-1.jpg

  6.  Drill holes .375” in diameter straight in using the drill press so the tube can go out and back into the elbow and go over the thumb press location.

  7. Angle the holes for the tube by clamping the elbow and using the hand drill to change the hole angles to match the tube angle.

  8. Push in the PVC and drill the hole in the PVC where the hole in the elbow is, making sure the PVC is rotated the way it should be.

  9. Connect the bulb to the 6” tube so that the air is pushed into the tube.

  10. Put the bulb in it’s cut out and push the tube through the two holes, widen or angle the holes if needed.

  11. Use a screw or pointy object to poke a hole in one side of the tube where it goes over the thumb pressing space, the thumb will hold in the air in the end.

    20160628_150126-1.jpg
  12. Super glue and hot glue the bulb into the PVC

  13. Cut the grip tape to a shape that will cover the PVC about 2”x5”

  14. Glue the grip tape on the back of the PVC