Step 2: Connecting motor and pulley
Cut about 2 feet of string to thread into the pulley. Loop around the pulley once and tie a knot that will allow the string to be secured to the internal channel of the pulley.
|
|
Lace one end of the thread through the two adjacent holes in the pulley and tie a knot there as shown. This will prevent thread from slipping around the center channel of the pulley and ensure that the pulley winds as it pulls. Double knot is necessary.
|
|
|
Connect the pulley on the mounting hub using the screws and nuts provided with the motor and pulley.
|
|
Attach the aluminum bracket, the motor and the mounting hub using the screws provided. Your motor is ready to be attached to the gripper board.
|